The orig set have a very flat top surface and crisp edge where the sides meet whereas the replacements have a very slight roundness to them. You'd see the difference if I used the orig V amongst the others; and sure as...you know...the only posts that would be different are the ones on the V if I was to drill the holes based upon the orig V this weekend. BTW, I decided to replace them as the orig ones have some pits and "bubbles" caused by corrosion over the years - so the plan is to make it all shiny and new. As of today however, I'm one V short of a great plan!
 
Old Thread: Hello . There have been no replies in this thread for 100 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Users who are viewing this thread