Picture for XFIRE
- Thread starter Black 03 Z06
- Start date
I was looking for something a bit more sporty, what about that one in behind with the high back bucket seat?
Thats actually a low back seat...its just thrown in there on top of an old tire.
Well then, I don't want that one either (LOL)
Thought the wagon pic above was interesting in our search for the mysterious trim versus bumper alignment issue. Notice that the short trim piece in front of the wheel well has two fastener holes while the bumper attachment is a single hole. So unless the front fender has undergone some ugly work the problem would seem to be holding up a 1000 pound chrome bumper with one bolt. 
Yes that's true, however, the masive 1" looking bracket attached to the frame rail should help carry a few hundred pounds of the weight as well...wait....that's a pressed piece of sheet metal....make no wonder the bumper wanted to fall down and drag the fender with it.Thought the wagon pic above was interesting in our search for the mysterious trim versus bumper alignment issue. Notice that the short trim piece in front of the wheel well has two fastener holes while the bumper attachment is a single hole. So unless the front fender has undergone some ugly work the problem would seem to be holding up a 1000 pound chrome bumper with one bolt.
So the solution would be ..... more holes?Yes that's true, however, the masive 1" looking bracket attached to the frame rail should help carry a few hundred pounds of the weight as well...wait....that's a pressed piece of sheet metal....make no wonder the bumper wanted to fall down and drag the fender with it.
See what happens when you run snow tires on the front of a rear wheel drive car......LOL
more holes would reduce the weight as well.... lol
Don't ever say that to yer misses(LOL)
Silly! That's the horn support.Yes that's true, however, the masive 1" looking bracket attached to the frame rail should help carry a few hundred pounds of the weight as well...wait....that's a pressed piece of sheet metal....make no wonder the bumper wanted to fall down and drag the fender with it.
See guys. Raise the hood and the bumper pretty much self aligns.......all's good!
That one must have the "Flexomatic" option.
How can you tell if the bumper is straight when they photograph like this ?
You can't, that's the genius of the picture....
The professional photographers were over at Cadillac...
Similar threads
-
Internet News Picture This: 2024 Prescott Vette Sette annual All-Corvette Show - Prescott Daily Courier- Started by VetteBot
- Replies: 0
-
-
-
-
Internet News Someone Found This One-Owner Corvette in a Barn and Rapidly Lost Interest - autoevolution
- Started by VetteBot
- Replies: 0