Install was pretty easy, dropped the wires behind the carpet but wanted to mount the controller somewhere that I could see easily. Below the start switch I couldn't see it without turning the wheel (not necessarily a good idea while driving) and in the centre console didn't seem great as I would always have to lift it up.
I dont have the HUD buttons and there is a gap there which isn't good for much. So I used the foam from the shipping box, folded it in half and then stuck a piece in the middle for a good pressure fit. Used a black piece of duct tape to cover it, with a slight overlap on to the plastic, and then stuck the unit to this
Can see it at a glance while driving and looks pretty clean I think. Just another mount idea for people looking like I was
Enjoying the unit as well, really cleans up that lag and can get quite aggressive if you want
Cheers
I dont have the HUD buttons and there is a gap there which isn't good for much. So I used the foam from the shipping box, folded it in half and then stuck a piece in the middle for a good pressure fit. Used a black piece of duct tape to cover it, with a slight overlap on to the plastic, and then stuck the unit to this
Can see it at a glance while driving and looks pretty clean I think. Just another mount idea for people looking like I was
Enjoying the unit as well, really cleans up that lag and can get quite aggressive if you want
Cheers