Torque tube issue
- Thread starter JSBVETTE
- Start date
You can send Manny a PM (Nasty98) and he should be able to ballpark it for you. Hopefully some of the local guys can chime in for you and get you in the right direction.
We may need a couple answers however,
What year is your Vette?
Manual or Automatic?
Were you told you need a new torque tube or does your car just have symptoms where you believe the bushings are gone?
Glad to have you on the forum! Keep pestering until you get your answer.
We may need a couple answers however,
What year is your Vette?
Manual or Automatic?
Were you told you need a new torque tube or does your car just have symptoms where you believe the bushings are gone?
Glad to have you on the forum! Keep pestering until you get your answer.
If it sounds like this it could be your Pilot bearing. Agree with Riley, check with Manny he is the guru 
https://www.youtube.com/watch?v=u_3DQSng0PM
https://www.youtube.com/watch?v=u_3DQSng0PM
Its always hard to tell from a video . This can be a number of things .
To re & re the th Torque tube with headers , is $800 plus parts .
If it were the the bushings , you would hear the noise all the way through the RPM range .
I am suspecting it could be the release bearing for the clutch .
Manny
To re & re the th Torque tube with headers , is $800 plus parts .
If it were the the bushings , you would hear the noise all the way through the RPM range .
I am suspecting it could be the release bearing for the clutch .
Manny
Wheaton just replaced my torque driveshaft. (At 10k km)Said original was 2mm short. They put z06 parts in. Good so far..
