Rear Wheel Bearing Tool

[1980C3cruiser]

Does anyone have a used rear wheel bearing tool they’ll sell me? This tool is required to set the proper preload/spacer width on the 2 rear bearings. I know I can buy it new. I’ll just use it once and toss it in my tool box for my heirs. Who probably may never want to work on a C3. Lol. Might as well see if anyone has one sitting in their toolbox, they used once. Thx.

Seen here: 1963-1982 Rear Wheel Bearing Set Up Tool | Corvette Depot (https://www.corvettedepot.ca/1963-1982-rear-wheel-bearing-set-up-tool?srsltid=AfmBOorT0_n5Kt_Yl2yiigbPryC9U-J93vgE9K_RJ2uolDmdL6unL6C3)

 

[RickWolf]

Lol. I need to get one too, to take apart and change the backing plates for the parking brake repair. And like you say I will use it once and probably never again. Too bad these can't be borrowed from part source, like other tools, I just did clutch change and needed a slide hammer to get out pilot bearing, borrowed tool and it was out in 5 seconds. After I wasted a day trying everything else

 

[12cents]

Guys, some Canadian Tire places rent out specialty tools and have you called around to some of the rental shops to see what they have?