I installed the fins this weekend. What should have been a hour project at most turned into 3 hours. The fins look good, in my opinion but the last top screw on the driver's side took 2 hours to tighten. I didn't raise the car, and I didn't remove the rear lower fascia. Either of these would have helped with the install, still quite happy with the result. Cheaper then a new diffuser.
Installed ACS diffuser fins on C7
- Thread starter tyho
- Start date
XFIRE82
Power User
....educate this old school guy with posting a pic, cause I have no idea what a diffuser is ( sounds electrical ) or the fins you are talking about.....
.....
.....
....educate this old school guy with posting a pic, cause I have no idea what a diffuser is ( sounds electrical ) or the fins you are talking about.....
I assume @tyho means something like this?
Post a pic would ya
XFIRE82
Power User
...probably a before and after pic would help me see what it is all about......
......
......
the picture above is after Michael, the picture of mine below is before.... I like the looks of it tyho....
- Thread starter
- #6
Yes, the four fins on the rear lower fascia. I'm not planning on racing, just like the look, more sporty
Post up a picture of yours tyho...
XFIRE82
Power User
....thanks Rruuff day, now I see. I guess this piece of plastic is related to what us old customisers call a roll pan when the back end was modded. Personally I like the factory look as there is some chrome/stainless there to add some class. But the new piece does look abit more aggressive.
Very nice Tyho! Wooooo!