HiVoltge

Active Member
Feb 11, 2009
179
0
richmond hill
VetteCoins
500
Car
2000 MN6 Coupe
Finally got around to repairing some nasty scratches on my CCW's..Followed directions posted in a DYI forum.. I have to admit I was skeptical at first and I was a little anxious about the process as I didn't want to make the wheels any worse...

what I started with
usedparts036.jpg


Masked and ready
usedparts037.jpg


Sanded with fine grit on my B&D mouse
usedparts039.jpg


wet sanded with 400/800/1000 grit
usedparts040.jpg



wet sanded with 2000 grit
usedparts064.jpg


Buffed with Mothers Billet and Pollished with Jellewers Pollish
usedparts065.jpg


They look new again... Those scratches are gone.!! The next step is to paint the barrels with POR Glisten Epoxy Clearcoat and they're ready for action..
Its important to take your time and use the diffrerent grits of sand paper in sequence. A little patience and elbow grease pays off...:)
 
Last edited:
Old Thread: Hello . There have been no replies in this thread for 100 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Users who are viewing this thread