Recent content by ggurface

Are z06 still going for over MSRP? My dealer said I can get one within 3-4 months and he has open allocations if I trade in my stingray

Wouldnt it be the same engine as base and a widebody? If following the previous formula.

Looks like his transmission broke

This thread is for the general discussion of the classified ad FS: C8 Z51 wing carbon flash. Please add to the discussion here.

I agree with this sentiment however I think there is a fourth legitimate reason: if you value performance above everything else. The Coupe is ~100 lbs lighter which is a lot in the car world. Lower center of gravity, easier to reach engine bay, and its reflected in the 0.1 faster 0-60 times.

One thing that is often missed in these discussions is the fact that wind noise and buffeting in coupe will be much worse. I already drive with earplugs on the highway with my HTC top down because it’s just too loud. Would be much worse in a coupe.

Its based on scraping the GM VIN Window sticker method. And there are only a set # of combinations for each vin. I think the only variables are HTC/Coupe, and 1l3/2l3/3lt. So you try those 6 combinations for every vin 5 digit ending (which is not a real variable, since it sequentially...

Easy fix to the v4 sound. Never let the car go in v4 mode by driving in manual or track

Available here: https://www.c8tracker.com/dealers Wilson Niblett #1 with 39 2023 c8's sold (as tracked by that website) Cullen #2 with 35 Spencer #3 (in Ontario) with 29 Hope this helps

Wait so $2k for something that only shows when the convertible top is midway up? Lmao

Thats a lot of coin for some visual mods.... wow I thought it would be cheaper.

This looks great. I like this combo more than the 5vm sideskirts which look a bit awkward and too big for me. How much did everything cost you OP?

Just curious why these cruises are generally starting so early? Is it because the owner demographic skews older so everyone is up by 7am or something?

Thanks, will check them out. You picked a great spec :)

Dealer wanted like $1350 + tax which seems excessive for a relatively straightforward job. Users on the american forum are saying they found shops that will charge 2 hours labor, which seems about right to me. Anyone got this done around the Toronto area? I'm in the northern end. Pic of my new...