Martys 76

I'm New Here
Nov 19, 2016
3
16
ottawa
VetteCoins
544
Car
76 corvette
My C3 pulls to the drivers side change calipers and pads still pulls. did a brake test and passenger side will not lock up
could it be the rotor or brake hose brake hose looks good no cracks not losing any fluid
 
You say you changed both calipers ? if yes , then the pass side may need to be bled until no air bubbles . If you are not getting any brake fluid to the pass side then the line or hose is blocked. I've seen blocked steel lines before. Can take the hose off the caliper and pump the brake pedal slightly, if shoots fluid then it is ok. If not take the hose off and see if you can blow through it , if yes then it is ok. Then check the steel line if any fluid is coming out from it, if not then it is blocked.
 
Old Thread: Hello . There have been no replies in this thread for 100 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Users who are viewing this thread