Reply to thread

Message

When the lock exceed the wheel, it's easy to make a notch whit the die grinder then make it turn whit the zip gun but when they are to deep, it's a different story. I use some extractor from Napa, part #ultrapro 62800. Its a kit whit 2 extractor that screw counterclook on the exterior of the lock. push it hard while you use the air gun. It save me lots of problem and doesn't damage the wheel. Can't remember how much it cost but works good. Removing the nut out of the extractor might be a little hard but very tight in a wise and using the air gun will make it. Good luck

[QUOTE="theboss, post: 78255, member: 1458"] When the lock exceed the wheel, it's easy to make a notch whit the die grinder then make it turn whit the zip gun but when they are to deep, it's a different story. I use some extractor from Napa, part #ultrapro 62800. Its a kit whit 2 extractor that screw counterclook on the exterior of the lock. push it hard while you use the air gun. It save me lots of problem and doesn't damage the wheel. Can't remember how much it cost but works good. Removing the nut out of the extractor might be a little hard but very tight in a wise and using the air gun will make it. Good luck [/QUOTE]

Verification