Recent content by teamo

  1. T

    heater box rebuild

    I never did find out exactly what is was used for. As suggested it is probably a baffle of some sort for air flow. I rebuilt and installed the box as is. Car is still not running yet but everything is back in place on the heater core and evaporator boxes.
  2. T

    Featured Fox Mustang!

    Great project. I also had a 78 Thunderbird, my first car. I bought a brand new 89 GT Mustang several years later. Wish I still had both of them. Good luck.
  3. T

    heater box rebuild

    Hi All, Rebuilding my heater box and there is a sheet metal part that is not on my box that is shown in multiple photos online. I also have a spare box that I purchased for parts and the part is not on that one either. The box pictured below is from an internet picture. The piece that I am...
  4. 1605453601351.png

    1605453601351.png

    • teamo
    • Media item
    • Comments: 0
    • Category: Corvette C3
  5. T

    firewall wire retainers

    perfect. Thanks again.
  6. T

    firewall wire retainers

    Thank you for the help. Is the bottom where the top of the booster sits?
  7. T

    rear bulkhead holes

    75 Coupe. Are there brackets or something missing from the back closing panel? There are 4 holes on each side.
  8. closing panel 1_LI.jpg

    closing panel 1_LI.jpg

    • teamo
    • Media item
    • Comments: 0
    • Category: Corvette C3
  9. T

    firewall wire retainers

    Hi All, I am trying to figure out exactly where to rivet the wiring/vacuum line clip into place. It was loose when I removed the forward harness. I've searched online and some of the pictures that I've seen show what seems to be a bolt with a nut and some appear to be riveted in different...
  10. brake pedal support_LI.jpg

    brake pedal support_LI.jpg

    • teamo
    • Media item
    • Comments: 0
    • Category: Corvette C3
  11. firewall_LI.jpg

    firewall_LI.jpg

    • teamo
    • Media item
    • Comments: 0
    • Category: Corvette C3
  12. T

    transmission cooler lines

    Trying to install my new pre-bent transmission cooler lines.When I removed the old lines they were all bent out of shape so I couldn't reference them for the new lines. The only clip that I see in the AIM is on the forward part of the frame underneath the lower control arm that uses a single...
  13. T

    column shift tube

    Sorry if I don't have my terms correct. I am rebuilding my tilt tele steering column (1975). The inner shift tube has broken free from the outer tube. There are slots and small holes on each side as well as a large hole towards the top. I have read that you can use epoxy in the holes to secure...
  14. T

    Wiring harness Trunk

    What year is the car? Looks like the seat belt interlock module that was mandated starting in 1974 and ran into the 1975 model year. It was discontinued mid 1975. The system was to disable the starter until the seat belts were buckled. There was also an orange colored relay/override switch on...
  15. T

    C3 Trunk Back Wall Piece

    I believe that the white box is the seat belt interlock module. This was part of the seat belt interlock that was federally mandated in 1974 and was discontinued in late 1975. If you look on the firewall on the right side there was also an orange colored relay that was part of the interlock...
See more
Top Bottom