Recent content by Russ K

Thanks, but not lowering the rear, I have since raised the front 1/2". There are way too many speed bumps in every parking lot & gas station to clear. The rear wheels pull in as they go up into the car, and will clear the fender. Also not planning on big brakes, but there is more than enough...

Just mounted the 315/30/19 Sport Cup rear tires. Rear wheels are 11" with a 65mm offset. Still have 1/2" to 11/16" clearance to the inner wheel house. Front wheels are 18x9.5 57mm offset with 265/35/18 Michelin PS2 that are a few years old. Hopefully, the traction will be better with the 418...

This classified has been closed by the advertiser.

Camshaft is sold. Russ Kemp

Way better drive ability, as the G5X3 114 has 10* valve overlap vs 4* with the EPS. I now have a Cam Motion 232/240/.620/.595/118+2, and it drives like stock due to the 0* overlap. Russ kemp

Russ K posted a new classified: EPS 234/242/.600/.615/117+6 camshaft for sale EPS 234/242/.600/.615/117+6 camshaft for sale Read more about the classified...

Riley, a customer of mine was looking for wheels for his 2003 ZO6. After getting a lot of misinformation, he's going with the same OZ wheels that are on my car in 19x11 65mm & 18x9.5 59mm sizes. And for tires I got him a deal on Nitto Invo 305/30/19 & 265/35/18. The wheels are on sale at the...

Riley, both wheels are nice, I prefer the Forgestars (way too many CCW wheels on Corvettes) in 18/19 dia. I don't see the offsets, but for the front use a 18x9.5 57-59mm offset, and 19x11 62-65mm offset. For tires, use 265/35/18 & 305/30/19. Don't use a 275/35/18 as the sidewall is taller than a...

Yes, same sensor. But you need to first check the wiring harness for any opens or shorts. I believe it unplugs just on top of the front engine cradle. As that harness is always flexing when turning the wheels or going over bumps. Get a service manual. Russ Kemp

I would first fix the C1225 code for the LF wheel speed sensor, as the EBCM looks at the wheel speed sensors to determine when the vehicle is going straight ahead. Then it will calibrate the steering sensor output so that it reads 0 when the steering is centered. So if your LF wheel speed is...

Actually, your low speed fans are set to come on at 200*F and off at 195*F. Your high speed fans are on at 205*F and off at 196*F. I would of set them lower if you had a 160*F stat. Russ Kemp

Camshaft is sold, but I have a set of Trick Flow dual valve springs, titanium retainers, locks, new valve seals & spring seats for stock heads for $150.00. These springs have 155 lbs @1.800 & 450 lbs @ 1.200. Russ Kemp

I always disable the 1-4 skip shift & turn off the 1-4 shift light when I tune the 6 speed manual cars using Hp Tuners. Russ Kemp

234/242 114+4 .600/.610 Russ Kemp

Reduced to $300.00 Russ Kemp